Description

Polymer80 PF940SC Jig Kit For PF940SC Frame Blanks

If you are building a compact handgun from the ground up, the polymer80 pf940sc jig kit for pf940sc frame blanks is the essential tooling you need to get the job done right. This jig kit is designed specifically for the PF940SC frame blank, giving you a precise, repeatable setup for completing your frame without guesswork. Whether you are a first-time builder or a seasoned hobbyist, this kit provides the alignment and support required to mill out your frame pockets and pin holes accurately.

Overview

The Polymer80 PF940SC Jig Kit is the official drilling and milling guide for the PF940SC subcompact frame blanks. It includes the jig block, drill bits, end mill, and alignment pins needed to finish your frame at home. This is not a universal jig — it is purpose-built for the PF940SC platform, meaning everything lines up exactly as it should. The kit allows you to complete the three critical steps of frame finishing: removing the trigger housing pocket, drilling the pin holes, and locating the front locking block. If you already have a PF940SC frame blank, this jig kit is the only way to complete it properly.

Features & Specs

This jig kit is built to the same quality standard as the frame blanks themselves. The hardened steel drill bits and end mill are sized specifically for the PF940SC dimensions, so you won’t have to second-guess bit sizes or alignment. The jig block is molded from impact-resistant polymer and features clearly marked indexing points.

• Includes jig block, 3 drill bits, end mill, and alignment pins for the PF940SC frame blank
• Molded indexing points for trigger pocket, rear rail, and front locking block
• Hardened steel bits sized to match PF940SC pin diameters exactly

The jig block also features a snap-in cover plate to hold the frame securely during milling. All components are packed in a resealable bag for easy storage between sessions. This is the same jig kit that Polymer80 ships with their complete frame kits, so you are getting factory-spec tooling.

• Snap-in cover plate holds frame tight during pocket milling
• Pre-drilled alignment holes for drill bushing use
• Compact size fits in a standard workbench drawer

Who It’s For

This polymer80 pf940sc jig kit for pf940sc frame blanks is for anyone who owns an unfinished PF940SC frame and wants to complete it themselves. It is ideal for the DIY builder who prefers to finish their own frame rather than send it to a gunsmith. If you are comfortable with a hand drill and a steady hand, this kit gives you the guidance you need. It also suits the enthusiast who builds multiple frames and wants a dedicated jig that won’t wear out after a few uses. The kit is not recommended for someone who has never worked with polymer frames before, but if you follow the included instructions, you will get clean results.

• Home builders finishing a PF940SC frame blank for the first time
• Experienced hobbyists who want a dedicated jig for subcompact builds
• Anyone who prefers hands-on frame finishing over gunsmith services

Shipping & FFL

This jig kit ships directly to your door. Because it is a tooling kit and not a firearm receiver, no FFL transfer is required. You can order it without visiting a licensed dealer. Standard shipping rates apply, and we ship to all US states where frame components are legal to own. Please check your local laws regarding frame blanks and jig kits before ordering. Polymer80 PF940SC jig kits are intended for personal use only and should be used in compliance with all applicable federal, state, and local regulations.